Support for SDX1200
- How to Activate an Accessory Kit* (Rhinestone, Emboss Kit, etc.) for the Cutting Machine.
- How Do I Perform Trial Cutting for Roll Feeder? (Test Cut)
- Retrieving Roll Feeder Data On the Machine and Cutting
- Using the trimmer blade to trim the end of the material
- Adjusting the Position of the Feed Roller
- What Should I Do If the Material is not being Cleanly Cut by the Trimmer Blade?
- The rolled material did not feed correctly.
- The Material to be Cut is Not Cleanly Cut with the Roll Feeder.
- What Should I Do If the Trimmer Blade Has Been Removed from the Trimmer?
- How to Install the Roll Feeder
- Care and Maintenance (Cleaning the Trimmer Blade)
- How should I make a pattern to be cut with the roll feeder?
- Cutting data is not displayed in Roll Feeder. Show More Show Less
Other FAQs Category
A guide to navigating our most common questions