Support for CM700
- Cut a thin fabric for the quilt piece. (How to use the High Tack Adhesive Fabric Support Sheet.)
- Cut the fabric other than quilt pieces. (How to use the Iron-On Fabric Appliqué Contact Sheet.)
- I adjust the blade extension and the cut pressure to the setting described in the Quick Reference Guide. But the result of cutting the material was not good. Show More Show Less
- The mat is fed in at an angle and is not fed during cutting / drawing.
- The material to be cut/drawn or original to be scanned peels off during cutting/scanning.
- There are deep cuts completely through the mat.
- What should I do if the entire pattern is not cut?
- Not all of the material to be cut is cut. Some areas remain uncut.
- What should I do if part of the material is not cut?
- What should I do if the scanned and cut positions are misaligned?
- I adjust the blade extension and the cut pressure to the setting described in the Quick Reference Guide. But the result of cutting the material was not good.
- The mat or the material catches on a feed roller during cutting/drawing. Show More Show Less
Other FAQs Category
A guide to navigating our most common questions